ANRIVERSRF CONTROLKNOWLEDGE CATEGORY
Wireless control design for motors, access systems, equipment and smart devices.
Yes, a wireless remote can run a DC linear actuator, but the RF link is only the command path. Check the actuator type, end limits, loaded current and stop behavior before choosing a reversing receiver. This field guide shows what to verify and what to test on the machine.
A wireless receiver can work perfectly and still give a PLC an unusable command. Check the input circuit, pulse timing, command handling and restart behavior before connecting it to the machine.
Yes—but keeping the buttons is easier than deciding who has control. A practical guide to LOCAL/REMOTE selection, held commands during handover, stop priority, and the checks to make before a retrofit leaves the workshop.
Yes—but only when the transmitter, RF protocol, receiver logic, and machine interlocks all support simultaneous commands. Button count alone proves nothing.
Usually, yes. The safest retrofit lets isolated receiver contacts imitate the machine’s existing pushbuttons or PLC inputs while leaving stop circuits, interlocks, and load switching intact.
Do not approve an RF control system because the relay clicked once on the bench. Test the installed power, output logic, real load, lost-signal behavior, range, pairing, and recovery while the machine is still easy to correct.